Installing The Speakers - Insignia NS-S5250 Guide De L'utilisateur

NS-S5250 5¼" 3-way 60-Watt Car Stereo Speakers

Installing the speakers

Note
To cut mounting holes:
1 Make sure that the negative terminal on the vehicle battery is
disconnected.
2 Select a mounting location that has enough depth to
accommodate the speakers.
3 Use the included template to mark the cutting area. The template
diameter should be 4.55 inches (115.7 mm). Screw hole
diameters should be 5 mm.
4.55"
(115.7 mm)
Rear
tray
4 Remove the vehicle panel that must be cut, then cut the hole in
the panel.
Installation kits are available from your dealer or local stereo
shop to help make your installation easier. These kits also
give your installation a clean, custom appearance. If you
have questions about installations methods, see a
professional auto sound dealer or installer for help.
www.insignia-products.com
Template
4.55"
(115.7 mm)
7