Cruise Control; Assembly Procedure - Skoda BEA 600 002A Instructions De Montage

CRUISE CONTROL

The accessories are intended for professional fitting. Škoda Auto recommends the fitting to
be carried out by its contract partners.
The set is designed for Škoda Octavia (1Z), Superb (3T) and Yeti (5L) cars.
GB
Cruise control can be activated only in combination with certain types of steering
column electronic control units. The variants valid as of 07/ 2008 are shown on Fig. 7.
If the steering column electronic control unit is replaced with another, the customer
bears the costs of it.
List of parts (fig. 1)
Part name
Change-over switch below the steering wheel
with the control of the cruise control
Interconnecting wire
Tightening tape
Protecting tube
Fastener

Assembly procedure

Perform the disassembly and reassembly of individual parts according to Skoda workshop
manual. During the fitting, the car battery must be disconnected.
- 2 -
- Replace the left part of the change-over switch under the steering wheel with the
change-over switch with the cruise control (A) from the set BEA 600 002A - applies for all
Octavia (1Z), Superb (3T) and Yeti (5L) vehicles.
(see Body – fitting works, Circuit diagrams, Fitting points)
At removing and re-fitting the steering wheel, it is indispensable to observe the posi-
tion of the steering wheel against the steering wheel shaft.
Note – The control unit of the electronics of the steering column and the switch module un-
der the steering wheel are sealed up with a yellow self-adhesive tape in some cars -arrow-.
This tape is informative only, can be damaged and does not relate to warranties.
- 3 -
applies for vehicles Škoda Octavia (1Z) by 05/ 2005
- Interconnect the terminal board (T20a/ PIN 13) of the electronics of the steering column
with the terminal board (T12d/ PIN 4 (blue)) in the separating compartment.
- For interconnection you can use wire (B) after adaptation. Cut the wire (on the side of the
engine control unit) to required length. Fit contact, order no. 000 979 132 or 000 979 132E,
from the catalogue of spare parts, to the end of the fire (for connection use the connecting
tube from the service kit). Connect the wire as shown on the picture.
- Tighten the wire using the tightening tapes to the existing electric wiring of the vehicle.
Pieces Position
1 A
1 B
13 C
1 D
1 E