Table Des Matières; Printer Setup - Custom Engineering KUBE II Guide D'utilisation

PRINTER SETUP

Setup stampante
Drucker setup
PRINTER NAME and
FIRMWARE RELEASE
PRINTER STATUS
PRINTER PARAMETERS
KEYS FUNCTIONS
KUBE II
PRINTER SETUP
SCODE...........................................< code >
PRINTER TYPE .............................Kube
PRINTING HEAD TYPE .................T80
INTERFACE ...................................RS232
PROGRAM MEMORY TEST..........OK
DYNAMIC RAM TEST....................OK
EEPROM TEST..............................OK
CUTTER TEST...............................OK
HEAD VOLTAGE
HEAD TEMPERATURE
POWER ON COUNTER
PAPER PRINTED
CUT COUNTER
RS232 Baud Rate .....................:
RS232 Data Length ...................:
RS232 Parity .............................:
RS232 Handshaking .................:
Busy Condition ..........................:
USB Address Number ...............:
Autofeed ....................................:
Print Mode .................................:
Chars / inch ...............................:
Speed / Quality..........................:
Printing Width ............................:
Notch Alignment ........................:
Notch Threshold ........................:
Notch Distance ..........................:
Total Cut (ESC i)........................:
PaperEnd Buffer Clear ..............:
PowerFail WakeUp Mode..........:
Print Density..............................:
[LF] key to enter setup
[OnOff] key to skip setup
36
rel.1.00
[ V] = 24.29
[°C] = 25
= 117
[cm] = 400
= 35
19200 bps
8 bits/chr
None
Hardware
RxFull
0
CR disabled
Normal
A=15 B=20 cpi
Normal
80mm[82.5 PaperW]
Disabled
2.00
0.00
Enabled
Disabled
LAST PWR State
0%