Replace The Blade; Store The Machine; Stand The Machine On End; Troubleshooting - GreenWorks Commercial LMB406 Manuel D'utilisation

8.2

REPLACE THE BLADE

23
22
21
WARNING
Use only approved replacement blades.
WARNING
Wear heavy gloves or wind cloth around the blade
when you touch the blade.
1. Stop the machine.
2. Make sure that the blades fully stop.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting screw and spacer with a
wrench or socket.
7. Remove the blade.
8. Install the new blade. Make sure that the two posts
engage the holes in the blade.
9. Put in the spacer and tighten the mounting screw
that you removed.
10. Do the same operation on the other blade.
8.3

STORE THE MACHINE

• Clean the machine before storage.
• Make sure the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person at an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
English
8.4

STAND THE MACHINE ON END

24
1. Remove the grass catcher.
2. Pull and turn the handle knobs 90°.
3. Fold down the handle.
4. Turn the handle knobs 90° to lock the handle into
position.
5. Stand the machine on end and make sure that the
brackets touch the floor.
Storage Switch
The machine has a storage switch that prevents its
startup in the storage position.
It is necessary to remove the safety key and the battery
pack to prevent accidental startup or unapproved use.
The storage switch does not replace this function.
9

TROUBLESHOOTING

Problem
The handle is
not in position.
11
Possible cause Solution
The bolts are not Adjust the height
engaged correct- of the handle
ly. and make sure
that the knobs
and bolts are
aligned correctly.
EN