Kenwood KTI-5 Mode D'emploi page 5

Attach the KTI-5 to the repeater Accessory Cabinet using the supplied
cushion. There are two methods of attaching the KTI-5:
1. Attach 4 cushions (G13-2339) on the 4 base corners of the KTI-5, and
place it into the Accessory Cabinet.
2. Attach the cushion (G1D-0077) to the base of the KTI-5, and attach
it to the Accessory Cabinet.
Cushion
(G13-2339)
oriEnTaTion
rear Panel
①
① DC Power supply connector cable (length: 2 m/ 6.56 ft)
Connect to an external DC power supply (DC 13.6 V negative
ground).
② n SynC jack
Connect to Repeater.
③ lan jack
Connect to Ethernet. Use a shielded, Category 5e or higher
standard LAN cable shorter than 3 meters.
④ Micro uSB jack (aB Type)
Factory use only.
⑤ ConTrol i/o connector (DB-25 pin)
Factory use only.
Cushion (G1D-0077)
Indicator (STATUS)
Indicators (LAN)
② ③ ④
Cushion
(G13-2339)
⑤
3