Power Supply Connections - König Electronic KN-STUDIO91 Mode D'emploi

Photo studio
1 2
4
5
Flash Energy
Typical recycle time
Stepless flash power control
Recommended modeling lamp
Flash colour temperature
Flash trigger
Trigger voltage
Operating voltage
Output precision
Operation:
Switch the unit ON and set the "Flash power control" and "Modeling lamp switch" as required. When the unit
has charged to the required level, the red "Ready" indicator will light. The "Test button" should be pressed to
ensure that the flash is of the required power. Plug in the "Sync cord" and connect to the camera shutter at "X"
synchronization. Alternatively, use the built-in "Photocell" or plug in the "Radio remote control receiver".

Power supply connections

220 V AC 50 Hz. Use the main lead supplied to connect to the main supply.
Main ON/OFF switch
Set the red illuminated On/Off switch to "
Flash power selection
The unit can offer stepless power variation from full to 1/8, rotate the power control to adjust the power you
need.
Charge
When first switched to " ", the red illuminated ON/OFF switch will light up. When the unit has charged to the
level set by the flash power selector, the red "Ready" Indicator will light up again. Your flash light is now ready.
ENGLISH
3
6
7
8
150 W
2 Seconds
Full to 1/8
E14 bulb 75 W
Approx. 5500 K
Light, sync cord, manual infrared, radio.
12 V
180-230 V
Within 1%
" to turn the unit ON.
2
1. Test button
2. Photocell
3. 'Ready' indicator
4. Mains ON/OFF
5. Fuse
6. Modeling lamp switch ON/OFF
7. Sync cord
8. Flash power control