König Electronic HC-LS10 Mode D'emploi page 2

Electronic luggage scale
Specifications
1. Room temperature display
2. Zero and tare
3. 0.44" (11.3 mm) LCD display
4. Low battery / overload indicator
5. Capacity: 50 kg / 110 lb
6. Graduation: 50g / 0.1 lb
7. Power: 1x 3V lithium cell (CR2032)
Key illustration
: Switch on/off (press for 2 seconds to switch the device off)
UNIT: Switch between weight and temperature measurements
Weighing
1. Strap the webbing belt through the luggage handle and
secure the hook of the belt onto the triangular ring.
2. Press to switch on the scale before lifting (ensure there
is no tension)
3. When the display shows zero, press UNIT to select the
weight unit.
4. To re-weigh: press Z/T to reset the display to zero.
5. Lift the scale gently. Make sure the scale is horizontal and
balanced. The scale starts weighing the luggage. Wait for
the weight reading to stop and stabilise. The display will
flash the accurate weight 3 times and then lock. The scale
will display the accurate weight for 2 minutes and will then
automatically switch off.
6. When the scale is unable to read the weight of your luggage,
press Z/T to reset the display to zero and try again. The
scale will automatically switch off after 1 minute of inactivity.
Power
The scale is powered by 1x 3 V (CR2032) lithium battery. When
you use the scale for the first time, open the battery case cover
ENGLISH
2