SCS Sentinel XO 403+BADGES Manuel D'installation Et D'utilisation page 6

6
cabling diagram xo
• Portier vidéo ou audio
J1
J2
J3
7
programming
Use the remote control to program the system.
Programming of the ID keys
1) Tape 0000 then # there is a BIP sound.
2) Tape * 62#, there is a bip sound.
3) Keep each ID keys one by one , and pass them in front of the key reader (There is a bip sound when you pass the key).
4) To finish the programming, take an ID keys already programmed and pass it in front of the keys reader.
5) The programming is finished.
Deprogramming ID keys
1) Tape 0000 then #, there is a bip sound.
2) Tape * 3#, there is a bip sound.
3) Keep each ID keys one by one , and pass them in front of the key reader (There is a bip sound when you pass the key).
4) To finish the deprogramming, take an ID keys already deprogrammed and pass it in front of the keys reader.
5) The deprogramming is finished.
Cancellation of the ID keys ( In case of loss)
1) Tape 0000 then #, there is a bip sound.
2) Tape * 4444#, after 3 seconds, there is a bip sound, all ID keys are cancelled.
403
J1
J2
White wires of
the keys reader
Black and red
wires of the keys
reader
A : Doorphone +
B : Doorphone –
C : 0V
D : 12V DC
12V
0V
-
+
12V
J3
A B C D
• Alimentation 12V DC
230V