Configuration - Velleman DEM171 Mode D'emploi

4. Overview
Refer to the illustrations on page 2 of this manual.
1 cover
2 USB connector
3 display
4 LED
5 MAX/MIN
5. Operation
 Adobe Reader software is required.
 Allow the logger to come to room
 The executable file for programming the
5.1

Configuration

It is possible to make configuration changes at any time before the
logging function is started. Once the logger is started, configuration
cannot be changed unless stopping the logging first.
1. Switch on the logger and connect it to a PC. The green LED will
light.
2. The Windows
folder does not open, click on [Folder] to view the files.
3. Open the file [PDF Logger Configuration] tool. Select your
language and check the calibration report by selecting
[Calibration Certificate]. The user-configurable parameters are:
o Sampling Rate: Select the sampling interval from 30 seconds to
2 hours.
o Start Delay: Select the start delay from 0 minutes to 24 hours.
Example: If the delay is 5 minutes and the sampling rate is
10 minutes, the first temperature measurement will be done
5 minutes after the [START] button has been pressed. All
following measurements will be at a 10-minute interval.
o Temperature Unit of Measurement: Select the temperature unit
that will be displayed in the PDF report.
V. 01 – 19/01/2017
temperature before generating the PDF
and Excel report.
logger is named [PDF Logger
Configuration Tool].
® file display window will appear. If the correct
DEM171
6
7
8
9
10
NOTE
4
START/STOP
NTC thermistor
MARK
clip
battery
©Velleman nv