Domo DO7324F Mode D'emploi page 22

USE
· Set the temperature button to MIN and the power button to OFF. Put the plug in the
socket.
· Turn the buttons to the required position. A red indicator light indicates that the appliance
is working.
Temperature button
· Use this button to control the temperature. When set to MIN, the
appliance is off.
· Turn the button towards MAX. The further you turn the button, the
hotter the air.
Power button
· You can use the power button to select between three different settings:
· Ventilation without heat
· Heat 1200 W
· Heat 2000W
· The higher the power, the faster the heating.
· Switch the appliance off by setting the temperature button to MIN and the power button
to OFF. Remove the plug from the socket.
· Note: before switching off the appliance, we advise you to operate it in fan position for 2 to
3 minutes in order to cool it down.
SAFETY DEVICES
· This heater is protected with an overheat protection that switches off the heater
automatically in case of overheat, e.g. due to the total or partial obstruction of the grids.
The overheating shut-off switches off the temperature inside when the appliance exceeds
the normal running temperature. The heating element will automatically stop working, the
motor will continue to operate, the internal heat shed. This protective device applies only
to the appliance itself and has no influence on room temperature regulation.
· In this case, unplug the appliance, wait about 10 minutes for it to cool and remove the
object that is obstructing the grids. Then switch it back on as described above. The
appliance should operate normally. Should the problem persist, please contact the nearest
customer service.
· Your appliance is also fitted with a safety switch situated underneath the base and which
switches off the appliance in case it is raised or tipped over. Therefore, it is absolutely
necessary to install the appliance on a flat stable surface. This switch is automatically
pressed when the appliance is installed on a flat surface.
22
DO7324F