Belkin OmniView F1DW101AeaAS Guide D'installation Rapide page 8

Step 5
Connect the Quad-Bus KVM-over-IP or CAT5 KVM Switch to the
Server Interface Module using the included Belkin CAT5e Patch Cable
or other CAT5 cable.
Step 6
Repeat steps 2 through 5 for each additional USB Sun server
you wish to connect.
Step 7
Power up all connected servers.
Step 8
Power up your Quad-Bus KVM-over-IP or CAT5 KVM Switch.
You are now ready to use your OmniView Quad-Bus Server Interface Module.
If you have any problems during installation, please refer to the OmniView
Quad-Bus KVM-over-IP or CAT5 KVM Switch User Manual.
Note:
Your server should recognize your Server Interface Module and automatically
install the HID USB driver if necessary.
Installing your Server Interface Module
8
P74936_F1DW101AeaAS_QIG.indb 8
Server
9/1/07 5:41:06 pm