Elkay 1000001858 Manuel D'installation/Entretien/Utilisation

Installer
To assure you install this model easily and correctly,
PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE STARTING THE INSTALLATION.
CHECK YOUR INSTALLATION FOR COMPLIANCE WITH ALL ELECTRICAL AND OTHER
APPLICABLE CODES. FOLLOW ALL WARNINGS AND CAUTIONS CAREFULLY.
After installation, leave these instructions with the customer for future reference.
WARNINGS
This device complies with part 15 of the FCC Rules. Operation is subject to the following two (2) conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not approved by the manufacturer could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The user should avoid prolonged exposure
within 20 cm of the antenna, which may exceed the FCC radio frequency exposure limits.
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. The user should avoid prolonged
exposure within 20 cm of the antenna which may exceed the exposure limits.
Cet équipement est conforme avec IC RSS - 102 des limites d'exposition aux rayonnements définies pour un environnement non contrôlé.
L'utilisateur doit éviter une exposition prolongée à 20 cm de l'antenne qui peut dépasser les limites d'exposition.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for
the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication
Conformément á la réglementation d'lndustrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type d'un gain maximal
(ou inférieur) approuvé pour l'émetteur par lndustrie Canada. Dans le but de réduire les risques de brouillage radioélectrique á l'intention des autres
utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e) ne dépasse pas l'intensité
nécessaire á l'établissement d'une communication satisfaisante.
1000001858
INSTALLATION, CARE & USE MANUAL
Manual de Instalación, Cuidado y Utilización
Manuel d'installation/entretien/utilisation
1000001858 Ethernet Base Station
1000001858 Estación Base Ethernet
1000001858 station de base Ethernet
THIS IS AN INDOOR APPLICATION ONLY!
THERE ARE NO USER SERVICEABLE PARTS ASSOCIATED
WITH THIS PRODUCT
TOOLS/ITEMS REQUIRED
BUT NOT SUPPLIED
• ETHERNET CABLE
• FASTENERS FOR WALL OR CEILING (2 REQ'D. IF WALL
OR CEILING MOUNTED)
Page 1
IMPORTANT
.
1000002101 (Rev. A- 10/14)