Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connection rating in
Oven type
sauna stove
internal controller
sauna stove
internal controller
Liquids:
The sauna stove is suitable for sauna liquids.
Please read the following carefully:
• O nly use water that meets the quality requirements for
domestic water.
• W ater that contains high levels of lime or iron will leave
residue on the stones and metal in the water tank.
• T o prevent scalds caused by rising steam whilst pouring
liquid over the stones, liquids should always be poured from
the side using a ladle.
• D ripping water may cause permanent marks on the cabin
floor.
• P our small amounts of liquid on to the stones; if you pour too
much liquid on to them you may suffer scalds.
• U se as much liquid as you are comfortable with, but do not
exceed a volume of 15 g/m³ of cabin volume.
• T he liquid should be poured straight on to the stones in the
stove and must be spread evenly over all the stones.
• I f you use liquid concentrates (for example essential oils),
follow the instructions for use provided by the manufacturer.
• U sing excessive concentrations of these products may
10
Weka_Anleitung_Saunaofen_IPX4.indd 10
Suitable for cabin
size
kW
in m
3
3,6
up to 6
4,5 - 9,0
approx. 6-14
Minimum cross-sections mm
Power supply
cable (silicone)
3x2,5
5x2,5
result in explosions.
• D o not use mixtures of alcoholic drinks or other additives
not recommended for use in saunas as they pose a risk of
fire, explosion and may be harmful.
• T he warranty will be voided if you fail to follow these
instructions.
Important! Liquids may cause marks on metal surfaces and
sauna stones. Sauna liquids with citrus fragrance may cause
rust patches as a result of their acid content. In this case you
should only use products in the diluted form specified by the
manufacturer.
Troubleshooting
The stove will not heat up
• Have you activated all the necessary switches?
• Has the fuse in the domestic installation tripped?
• Have you set the temperature controller correctly?
• Have you pre-set the time switch?
• R CCB trips – see the section entitled "Testing the insulation
resistance"
The stove causes "cracking noises"
• T he housing parts and heating elements expand when the
stove is heating up or operating. The heating elements may
move the sauna stones and cause noises. Cracking noises
are normal and are not grounds for complaint.
Sauna stones split and cause an odor
• Use only sauna stones recommended by the manufacturer.
• Sauna stones are too old; replace them.
The cabin does not get hot enough
• The sauna stove is too small
• E xcessive temperature loss from the sauna cabin, for
example due to poor or lack of sealing.
• I ncorrect display on the sauna thermometer. Mount the
thermometer higher and at a distance of approx. 3 cm from
the sauna wall.
• H ave a defective heating element (heating element does
not glow) checked and measured by an electrician.
(copper cable)
2
Fuse in A
16
16
13.07.17 10:03
Publicité
Table des Matières
