Operating Elements And Connections - Monacor ATS-16R Mode D'emploi

Audio Transmission System
These instructions are intended for users without
any specific technical knowledge. Please read the
instructions carefully prior to operation and keep
them for later reference. All operating elements and
connections described can be found on the fold-out
page 3.

1 Operating Elements and Connections

(fig. 1: transmitter, fig. 2: receiver)
1 Bicolour power LED:
shows green during operation
on the transmitter: to indicate transmission
of a radio signal;
on the receiver: to indicate reception of a ra-
dio signal from the transmitter;
when it changes to red, the batteries are almost
discharged
2 Red battery status LED
lights up when the batteries are completely
discharged
3 Adjusting wheel to select the transmission
channel
4 Power switch and volume control
5 On the transmitter:
internal microphone; will be switched off
when the jack MIC. (6) or the jack AUX IN
(10) is connected
On the receiver:
opening to insert the earphone ET-16*
(acoustic tube with earpiece, will transmit
the sound of the internal speaker directly to
your ear)
6 On the transmitter:
3.5 mm jack MIC. to connect the supplied
tie clip microphone or the neck microphone
ECM-16N*; this microphone input will be
switched off when the jack AUX IN (10) is
connected
*available as an accessory
8
On the receiver:
3.5 mm jack EAR. to connect the supplied ear-
phone; the internal speaker will be switched
off when the jack is connected
7 Belt clip
8 Battery compartment cover
9 Contacts to charge the inserted rechargeable
batteries via the charging station ATS-16PS* or
the charging case ATS-36C*
10 On the transmitter:
line level input jack AUX IN (3.5 mm jack,
mono) to connect an audio unit (e. g. CD
player)
On the receiver:
line level output jack AUX OUT (3.5 mm jack,
stereo) to connect an amplifier
11 Power supply jack to connect a power supply
unit with an output voltage of ⎓ 5 V , as an
alternative to operation via batteries
dimensions of the connector plug:
3.5 / 1.3 mm (⌀ outside / inside),
inside contact = positive pole
Attention: When connecting a power supply
unit, make sure that the battery compartment
ist empty.
2 Important Notes
The unit corresponds to all relevant directives of the
EU and is therefore marked with
•
The unit is suitable for indoor use only. Protect
it against humidity and heat (admissible ambient
temperature range 0 – 40 °C).
•
For cleaning only use a dry, soft cloth; never use
chemicals or water.
•
Always insert two batteries of the same type.
•
If the unit is not used for a longer period of time,
remove the batteries as a precaution to prevent
damage to the unit in case of battery leakage.
.