Replacing The Lamp; Closing The Door - Leonard LK1203 Notice D'utilisation

20 Leonard
Problem
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.

Replacing the lamp

CAUTION! Disconnect the plug
from the mains socket.
1. At the same time, with the fingers
expand up and down the transparent
cover and unhook it in the direction of
the arrows.
2
Possible cause
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
1
1
Solution
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
2. Replace the lamp with one of the same
power and shape, specifically designed
for household appliances. (the
maximum power is shown on the light
bulb cover).
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised
Service Centre.