Publicité
Installation Instructions
INSTALLATION
MOUNT INSTALLATION
WARNING:
Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer's responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
1.
Level mount (A) at desired height. Using mount (A) as a
template, mark locations of four pilot holes (See Figure 1).
Ensure marks are in the center of wood studs.
(H) x 4
(G) x 4
3
Figure 1
2.
Drill 7/32" (5.5mm) diameter pilot holes into wood studs
(See Figure 1). Ensure pilot holes are straight.
3.
Using 1/2" (12.7mm) socket wrench, install four 5/16" x
2-1/2" (7.9mm x 63.5mm) hex head lag screws (G) and four
5/16" flat washers (H) through front plate access holes and
rear mounting slots, into pilot holes (See Figure 1).
Securely tighten lag screws.
CENTRAL PROCESSING UNIT (CPU)
INSTALLATION
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer's responsibility to make sure the combined weight of
all components attached to the PWC-2000 does not exceed
200 lbs (90 kg).
1.
Using key (F), remove and retain upper front plate attach
screws and washers (See Figure 2).
1
x4
2
x4
NOTE:
Lower front plate attach screws may remain installed.
2.
Tilt front plate away from wall and then lift out of lower front
plate attach screws (See Figure 3). Place front plate on
protective surface.
2
3.
Loosely thread strap (E) through side plates so that buckle
is in front (See Figure 4).
3
PWC-2000
x2
1
Figure 2
Figure 3
Figure 4
7
Publicité
