Étape 7 - Installation Des Pvc - Kalia KAMO Instructions D'installation

Porte de douche à pivot à 2 panneaux (36'' x 77''), installation en alcôve
Table des Matières

Publicité

INSTALLATION EN ALCÔVE/ALCOVE INSTALLATION
Étape 7 - Installation des PVC
En utilisant un maillet en caoutchouc, installer l'aimant (#48)
sur le long du verre de la porte et installer le déflecteur d'eau
du bas de porte (#33).
En commençant par le haut de la porte, installer le déflecteur
d'eau (#2), ensuite le (#3) et finir le bas de la porte avec
l'autre (#2) (fig. 7.1).
Sur le mur opposé, mesurer la distance pour positionner le
montant mural. Le montant mural doit être installé à 28.5
mm (1 1/8'') du coin de la base vers l'intérieur (fig 7.2).
Mettre le montant mural de niveau. Marquer l'emplacement
des trous du montant mural au mur. Percer des trous de 6
mm (1/4'') pour un mur de céramique (ajouter du calfeutrant
pour un mur de céramique seulement) et installer les chevilles
d'ancrage fournies (fig. 7.4).
Pour toutes autres épaisseurs ou types de revêtement mural,
utiliser des ancrages appropriés.
Remettre le montant mural en position et le fixer au mur à
l'aide des vis fournies (fig. 7.4).
Installer l'aimant d'aimant en PVC noir (#48) en forme de L 90°.
48
33
102502_RevF
2
3
48
Using a rubber mallet you can install the mobile panel door
magnet (#48) all along the side of the glass door (#33).
Install the bottom door water deflector
Starting at the top of the mobile panel, install deflector (#2),
then (#3) and then the bottom another (#2).
On the opposite wall, measure the distance in order to position
the wall jamb. The wall jamb must be positionned at 28.5 mm
(1 1/8'') inwards starting at the corner of the base (fig 7.2).
Level the wall-jamb. Mark the locations of the holes using the
pre-drilled holes in the wall-jamb. Drill 6 mm (1/4'') holes in
the ceramic tiles (add silicone only for the ceramic tile) and
insert the wall anchors provided (fig. 7.4).
For any other wall covering type and/or thickness, use
appropriated anchors.
Position the wall-jamb and secure it using the provided screws
(fig. 7.4).
Install the 90° L shape black magnet PVC (#48).
Fig. 7.1
Fig. 7.4
E
2
Step 7 - PVC installation
Fig. 7.2
28.5 mm
(1 1/8'')
50
49
D
C
7
6
51
Ø 6 mm
"
1/4
B
50
13

Publicité

Table des Matières
loading

Table des Matières