SBS Sport Runway Pro Mode D'emploi page 4

UK
THE HEADSET STATUS
Paring Mode: the headset can be searched the indicator light flashes and
blue alternately.
Not connected: the headset is not connected with device; blue light will
flash once each 2 seconds.
Standby Mode: the headset is connected with the device, and not any other
operations, without any indicator light.
Call State: when in a call, without any indicator light.
Charging Mode: the indicator light turns red while being charged, and will
turn blue automatically after being full charged.
Low Voltege State: when the battery's voltage below 3.3V, the indicator li-
ght flashed red, the speaker prompt once in a while.
CHARGING YOUR HEADSET
1. Prior to using the headset for the first time if not used for a long time,
please fully charge the battery.
2. Approximately 2 hours are required to fully charge the headset.
3. The indicator light turns red while being charged, and will turn blue auto-
matically after being fully charged.
4. When the headset is running out battery, the indicator light will flash red
(the headset will switch off tomatically when the battery is drained). Ple-
ase charge the headset as above steps in time to prolong the battery's
useful life (Charging indication will be delayed for a few minutes if the
headset has not been used for a long time or the battery is empty).
TURNING ON HEADSET
Separate the magnetic earphones, until you hear "Power on", the indicator
light turns blue for 1 second, then the headset will enter into ON MODE. The
headset will be connected automatically (when the headset isn't connect to
any other Bluetooth® headsets and the pairing list is empty, the headset will
enter into pairing mode automatically).
TURNING OFF HEADSET
Touch the magnetic earphones, until you hear "Power off", the indicator light
turns red for 1 second, then the headset will enter into OFF MODE.
Note: headset isn't connected with any devices within 200 seconds, it will
automatically turn.
PAIRING YOUR HEADSET
1. Ensure the headset is off, and the distance between your headset and
phone is within 1 meter to activate the Bluetooth® function on the phone.
2. Separate the magnetic earphones, then the headset will enter into pai-
ring mode automatically (the handset is not connected with any device
before). The pairing time are about 120 seconds, if the headset can't suc-
cessfully connected with any devices within 120 seconds, it will automa-
tically enter into standby mode.
3. Search Bluetooth® devices: see the user guide of your phone for in-
structions.
4. Select the headset model from the devices list of the phone.
5. Select the headset model (if the version of the phone is or under 2.0, you
should input pairing code "0000", and confirm). Later you could hear "Pai-
red" and then "Your Phone is Connected" (if the pairing cannot be comple-
ted within 120 seconds after the PAIRING MODE has been activated, the
headset will enter into the STANDBY MODE. Please repeat above steps to
do the pairing again).
6. Ensure there is no obstruction between your headset and phone and wi-
thin effective distance, you can use the headset freely.
7. Under the circumstance of power off, once you turn on the headset again,
it will connect the paired phone automatically within operation range.
4