ExPelec XLIGHT 100 LED Manuel D'utilisation page 2

CAUTION
Keep this device away from rain and moisture! Unplug mains lead before opening the housing! Every person involved
with the installation, operation and maintenance of this device :
- Has to be qualified
- Follow the instructions of this manual
SAFETY INSTRUCTIONS
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or
his service agent or a similar qualified person in order to avoid a hazard
CAUTION : Be careful with your operations. With a dangerous voltage you can suffer a dangerous when touching the
wires!
This device has left our premises in absolutely perfect condition. In order to maintain this condition and to ensure a safe
operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written in this user
manual.
Important
- Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not accept
liability for any resulting defects or problems.
- Keep away from heaters and other heating sources!
- If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on
immediately. The arising condensation water might damage your device. Leave the device switched off until it has
reached room temperature.
- Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent
that their effectiveness is impaired, for example by cracks or deep scratches.
- Always disconnect from the mains, when the device is not in user or before cleaning it.
- Please note that damages caused by manual modifications on the device or unauthorized operation by
unqualified persons are not subject to warranty.
- Keep away children and amateurs from the device!
MUSIC ACTIVE
Led color change and mix-color are triggered by low bass. If the unit is not triggered by music within 10secs, it will exit
automatically . Under this situation, LEDs is lightless and the motor stop to spin.
MANUAL MODE
- Put the switch in "
- Put the switch in "0" position, the motor will stop to rotate and can not be controlled by music. Put the switch in
" " position, the motor will rotate with three sates of clockwise direction, counter-clockwise direction and static
二
mode . Under this mode , if the unit is not triggered by music within 10secs, it will exit automatically . Under this
situation, LEDs is lightless and the motor stop to spin
SPECIFICATIONS
- Motor : AC 230/50Hz 15R/MIN 4W*1pcs
- Power input : AC230V 50HZ
- LED System : RGB/3IN1/3W*2pcs
- Power draw : 13W max.
- Fuse : 1A/250V
- Weight :1.6Kg
- Dimension(L x Ø) :152 x195mm
" position , the motor will rotate with the unit all the time and can not be affected by music.
一
XLIGHT 100 LED
USER MANUAL