Handle Assembly - Coleman 9937 Série Notice D'emploi

Components
■ Remove the components from the carton and
discard all packing components.
■ Wash the oil and food contact surfaces with hot
soapy water and dry completely. These items
include the Wire Basket, Oil Reservoir, and the
Thermometer. Wipe the inside and outside
surfaces with a clean damp cloth and dry
completely.
■ Set the fryer on a sturdy, flat surface. For
outdoor use only.

Handle Assembly

■ Attach the Handle Assembly with two screws
(Fig. 1). The screwdriver is not included.
To Set Up
■ To close, push the lid down until it snaps into
the closed position (Fig. 2).
■ To open the lid, slide the lid release button to
the left (Fig. 3).
■ To place the handle in the storage position,
slide the handle release button, pull the handle
outward, then lower the handle (Fig. 4).
■ Raise the handle to the operating position.
It will snap into place (Fig. 5).
Fig. 1
■ Remove the basket and fill the oil reservoir with
cooking oil to the "MAX" fill line, indicated by the
marks on the oil reservoir (Fig. 6).
■ Insert the thermometer into the thermometer
Fig. 2
holder and close the lid (Fig. 7).
Fig. 3
■ Turn off control knob
(Fig. 8).
English-5
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8