Styling Ribbon Curly Hair - Thane International Tourmaline Ceramic Styler Mode D'emploi

IM_TCS_Ceramic_A5_sw.qxd 30.09.2005
Figure 4-1
Figure 4-2
Figure 4-3
13
11:44 Uhr Seite 13
4.5

Styling Ribbon Curly Hair

Step 1: Wash hair thoroughly (optional), dry and comb it through well.
Separate out a section of hair - width of 3 fingers (or around 5cm); the thinner
Step 2:
the section, the more evident the results.
Step 3: Apply hair styling lotion in moderate quantities (optional).
Step 4: Place section of hair between the heated Tourmaline ceramic plates near the
hairline. (see Figure 4-1)
Step 5: Gently wind the section of hair around the TCS. (see Figure 4-2)
Step 6: Slowly "roll" the TCS in the direction of a winding process (step 5).
Note: Never stop for more than two (2) seconds at any one point on the section
of hair being styled. Whichever technique you use, do not hesitate to repeat the
process a few times for smooth, silky and shiny hair.
Step 7: Repeat steps 2 to 6 with the remaining sections of hair.
Instruction Manual