Hold Function; Display Lighting - LaserLiner RollPilot D12 Mode D'emploi

2
ON/OFF
!
The Hold function must be deactivated in order to start the measurement.
4

Display lighting

If visibility is poor, switch on the display lighting. In
order to preserve the batteries, the lighting switches
off automatically after 15 seconds. Simply press the
button again to switch the lighting back on.
5
Select unit of measure
m (cm) / ft (in)
7
Save measured value
The device has an internal measured value memory
for storing 5 entries. The selected memory location
is indicated by M1...M5 ashing.
Device ON
1x
Measurement
!
Previously saved measured values are overwritten.
!
The value M1 is always shown when the memory function is activated. The current measured
value appears again as soon as it has been saved to the required location (M1 - M5).
06 GB
3
The Hold function is active when the Hold symbol
appears on the display and the measured value
ashes. The current measured value is held.
2 sec
6
The current measured value is deleted.
Select memory location
1x

Hold function

2 sec
Delete measured value
2 sec
Save
1x
Exit menu
1x