Werner AA1510 Instructions D'installation page 10

(STEP 9 CONTINUED FROM PREVIOUS PAGE)
5. Pass the latch (A1) through the door hole from the
underside such that the position pointer points toward
the door edge (See Figure O).
6. Place the travel stop ring (A2) over the latch (A1) such
that the screw hole is at 45 degrees to the door center
line (See Figures O and P).
7. Place the latch catch (A3) over the latch (A1) and locate
into the latch groove such that the latch catch points
toward the door near edge and fully locates within the
travel stop ring (A2) (See Figures O and P).
8. Secure the travel stop ring (A2) using 12mm screw (A7).
9. Secure the catch assembly with M12 nut (A4) ensuring
the nut is tightened sufficiently to allow the catch to
rotate freely without any looseness (See Figure P).
Step 10
Attaching the Location Bracket
TOOLS REQUIRED
STEPLADDER
AWL
LARGE FLAT SCREWDRIVER
PHILLIPS SCREWDRIVER (small and medium)
TAPE MEASURE/RULER
PENCIL
When turned to the correct position, the catch lever will
engage in the location bracket to hold the door shut. Attach
as follows:
1. Mark a vertical line on the inside of the door jam
corresponding with the center line of the door catch
(See Figure Q).
2. Position the catch location bracket (A5) along the
bottom edge of the wood door jam (See Figure R).
3. Match up the indent mark on the bracket with the
vertical center line.
4. Make guide holes with the awl and attach using 2 of
the 3/4" wood screws supplied (A6).
5. Apply door labels, P/N103552-01 and P/N103553-01,
to the top side of the door, inside the attic.
9
A4
A3
A2
A1
A4
A3
A7
A2
PARTS REQUIRED
A5. (1) LOCATION BRACKET
A6. (2) 3/4" WOOD SCREWS
(1) "WARNING" LABEL P/N103552-01
(1) "HOW TO USE" LABEL P/N103553-01
Figure Q
Center line
A6
Tabs flush with
bottom of door jam
Figure R
Screw hole
Door
Figure O
A3
A2
A1
Figure P
A5
Thickness
of Door
45°