Installation; Installing The Appliance - Thermador PROFESSIONAL PSO301M Manuel D'installation

Installation

Installing the Appliance

Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally.
1. Remove and discard packing materials.
2. Remove all items from the oven to assure oven door
does not get damaged.
3. Verify that the cabinet opening is flat and level.
4. Carefully place the oven in the opening. Resting the
oven on the cabinet base support, slide the unit into the
opening until it is approximately 6" (152 mm) from
being fully installed.
5. Guide the pigtail through the opening of the adjacent
cabinet or base support as the oven is slid into position.
Verify the pigtail is not trapped between the oven and
cabinet wall.
6. Position the steam oven fully in the cabinet opening.
7. Gently open and close the oven door to check
operation and to verify that there is no interference.
English 4
CAUTION:
Securing to Cabinet
1. Open the oven door and locate the two mounting holes
on each side of the oven.
2. Use a 1/16" (1.588 mm) drill bit to drill pilot holes into
the cabinet.
3. Using the mounting screws provided, secure the oven
to the cabinet.