Danby Parcel Guard DPG37UN Manuel D'installation page 5

INSTALLATION INSTRUCTIONS
INSTALLATION
There are two methods that can be used to install
the Parcel Guard depending on what installation
location is available. Decide which option is best for
your chosen location and follow the steps below.
A. Secured through the bottom
1. Remove the platform at the bottom of the Parcel
Guard. Two holes are pre-drilled in the bottom
of the cabinet.
2. Place the Parcel Guard on the fl oor or structure
that it will be secured to.
3. Use a pen or pencil to mark the hole locations
through the pre-drilled holes.
4. Move the Parcel Guard out of the way and then
use a power drill and a 1/4" drill bit to create
guide holes for the bolts or screws, at least 2.5"
deep for wood screws and at least 3.75" deep
for concrete bolts.
5. Replace the Parcel Guard and insert the wood
screws or concrete bolts with washers into the
holes. Use a wrench to tighten the wood screw.
Tighten the nut on the concrete bolts and the
sleeves will expand to secure the bolt.
B. Secured through the rear
1. Use a power drill and a 1/4" drill bit to create
holes in the marked locations on the back wall
of the Parcel Guard.
2. Place the Parcel Guard against the wall or
structure that it will be secured to.
3. Use a pen or pencil to mark the hole locations
through the drilled holes.
4. Move the Parcel Guard out of the way and then
use a power drill and a 1/4" drill bit to create
guide holes for the bolts or screws, at least 2.5"
deep for wood screws.
5. Replace the Parcel Guard and insert the wood
screws with washers into the holes. Use a
wrench to tighten the wood screw.
B
A
4