Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
ConneCtion to tHe exCaVator
FMr 706 is equipped with clamps and magnets for attachment.
sWitCH on
press on/oFF switch once – all leds are flashing.
after switching on FMr 706 is in coarse detecting mode.
pressing on/oFF again switches unit between fine and coarse detecting mode.
Fine / Coarse deteCtion
Change with on/oFF switch
Fine = the 2 inner leds „a" are flashing 3 times
Coarse = the 2 outer leds „B" are flashing 3 times
sWitCH oFF
press on/oFF switch for 2 sec.
led displaY
2 upper red leds flashing
= move FMr 706 upwards
Middle green led flashing
= FMr 706 on level
2 lower red leds flashing
= move FMr 706 downwards
displaY Frp 707
Connect Frp 707 and FMr 706 by use of connecting cable 14 to sockets 8 and 9. Fix Frp 707 in the
cabine of the machine. now the receiver can be observed conveniently by the display even if the positi-
on of the receiver is above the cabine.
Frp 707 has no own power supply. it is powered by FMr 706.
11
Publicité
Table des Matières
