Frequently Asked Questions - Marmitek CONNECT 236 Guide Utilisateur

Press the "REC" button, the Control 236 will return to the operation mode.
Note:
1. During the setting, the mode will return to the previous stage if there is no input for 10 sec.
2. Unplugging the AC Power adapter will clear the REC settings.
3. In REC mode, the "<"/ ">" buttons still will change the channel.
4. You can also use the Remote Control for changing the channel.

FREQUENTLY ASKED QUESTIONS

No picture
Check to verify that;
- your Scart Cable is properly connected to your system and the Connect 236.
- your Scart Cable is properly plugged into your TV from the Connect 236 Output.
- you have selected the correct input channel.
- your TV is on the appropriate video input.
- your TV and Connect 236 are turned on.
No sound
- Check the connecting cables.
- Check the volume setting of the TV.
- Check whether the audio signal is transmitted by the cable used (S-VIDEO cables or
partially pinned Scart cables do not transmit audio).
- Check to verify that your TV and system are turned on.
The image is very grainy/there is background interference
- Switch off equipment which is not being used. Sometimes equipment transmits a very
strong signal, which can cause interference.
- Check the quality of the cables used.
CONNECT 236™ 13