Range Hood Care; Range Hood Lamps; Cleaning - Jennair JXW9030HP Instructions D'installation Et Guide D'utilisation Et D'entretien

Range Hood Lamps

Replacing a Halogen Lamp
Turn off the range hood and allow the halogen lamp to cool.
To avoid damage or decreasing the life of the new bulb, do
not touch bulb with bare fingers. Replace bulb, using tissue or
wearing cotton gloves to handle bulb.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect power.
2. Push up on the lens and turn it counterclockwise.
3. Remove the bulb and replace it with a 120 V, 50 W maximum
halogen bulb with a GU10 base. Turn it clockwise to lock it
into place.
4. Repeat steps 2 and 3 for the other bulb if needed.
5. Reconnect power.
Replacing the Infrared Heat Lamps
Turn off the range hood and allow the infrared heat lamp to cool.
To avoid damage or decreasing the life of the new lamp, do not
touch lamp with bare fingers. Replace lamp, using tissue or
wearing cotton gloves to handle lamp.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect power.
2. Twist lamp counterclockwise to remove.
3. Remove the lamp and replace it with a 120 V, 175 W
maximum, PAR38 IR lamp made for E-26 base. Twist lamp
clockwise to screw it into place.

RANGE HOOD CARE

4. Repeat steps 2 and 3 for the other lamp if needed.
5. Reconnect power.
Exterior surfaces:
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads. Rub in direction of the grain line to
avoid scratching the surface.
Always wipe dry to avoid water marks.
■
■
■
Metal Filters and Drip Trays:
Use 2 hands to remove filters. Grasp filter handles, pull toward
the front of range hood and pull down on the rear handle to
remove. Repeat for each filter.
Remove grease drip tray.
Wash metal filters and grease trays as needed in dishwasher or
hot detergent solution to clean.
Replace grease drip tray.
Reinstall filters, grasp filter handles and place front edge of filter
into the hood. Push up on the back handle and set rear of filter
into the drip tray to secure. Repeat for each filter.
The range hood is equipped with a thermal protector to avoid
overheating conditions. If the range hood shuts off while in use,
move the blower switch to the Off position. Wait approximately
60 minutes, then move the blower switch to the first position to
restart the range hood.

Cleaning

Stainless Steel Cleaner and Polish.
Mild liquid detergent and water.
Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
A
A. Grease filter
A
A. Drip tray
A
A. Grease filter
Thermal Protector
13