Cleaning And Maintenance - Beurer babycare BY 52 Mode D'emploi

3. Press the rapid heat-up button
The display now continuously shows the remaining warming time. The display starts to flash
one minute before the end of the warming process. The warming process stops once the
pre-specified warming time has elapsed. The heat LED and the display go out.
Starting the warming process without prior warming:
1. Press the button to switch the device on. The current temperature is shown on the
display. The default setting is 37 °C.
2. To enter the temperature, press the
temperature for keeping the food/drink warm (between 35 °C and 85 °C). The temperature
increases in the steps 37, 38, 40, 45, 50, 60, 70, 80 until the display reaches "85" and then
begins again at 35 °C.
3. Now press the
Ending the warming/keeping warm process:
1. Press the button for 2 seconds.
The display and the heater are switched off.
2. Remove the bottle/jar using the lifter.
3. Unplug the mains cable after each usage, pour all the water out and dry the device with a
cloth.
• Shake the bottle or stir the food in the jar.
• Check that it is the correct temperature.
• To prevent the breeding of bacteria, which multiply fastest in the temperature range
from around 32°C to 42°C, please use the heated baby food as soon as possible.
• We do not recommend keeping the food warm for any longer, as this can cause
important vitamins to be lost.
• For hygienic and microbiological reasons, do not reheat food that has already been
heated.
• Take care not to overheat food/liquids.

8. Cleaning and maintenance

The service life of the device depends on its careful handling:
• To extend the service life of the device, we recommend that it is not (continuously) operated
in the high temperature range.
• Use boiled or filtered water for warming baby food. This will reduce the build-up of lime
scale.
• Unplug the device before cleaning.
• To clean the device, use only a damp cloth. Do not use any scouring agents or other clean-
ing products.
• Descale the device using vinegar or citric acid. Place the lifter in the device, mix 50 ml of
household vinegar with 100 ml of cold water or a packet of citric acid with 200 ml of cold
water and pour this solution into the device. Leave the solution to work until the lime scale
has been removed; do not operate the device during this time. Pour the liquid away, rinse
the device out thoroughly and finally dry it with a cloth.
• Descale the device approx. every four weeks.
12
again to start the warming process.
button again to start the keeping warm process.
button repeatedly until you have reached the desired