ELLECI SMART 500 Manuel D'utilisation Et D'entretien page 9

Holes for the taps collection
The sink comes to you with pre-prepared semi-bores of 35mm on both sides.
This lets you choose the side where you wish to install the tap. After deciding which side you wish to use (same side of rear pipe
unions), the hole can be completed using a DIAMOND CORE installed on a manual drill, taking care to work from the non- visible
side.
The reversibility is given by the positioning of the caps and pipe unions of the drain.
Depending on the positioning of the caps and rpipe unions it is established the chosen side.
1. Remove the screws of the front ELLECI caps (pic.1)
2. Remove the screws of the rear pipe unions (pic.2)
3. Position the ELLECI caps on the opposite side, where once there were the pipe unions (pic.1)
4. Position the pipe unions on the opposite side, where once there were the ELLECI caps (pic.2)
INSTALLATION INSTRUCTIONS
REVERSIBILITY
Reversibility process for SIR SMART
fig.1
EN
fig.2
08