Hifonics Triton Série Mode D'emploi page 8

Please read the user's manual carefully before the installation and the first operation
of the device.
SPECIFICATIONS
Output Power RMS
Output Power Max.
Lowpass Filter
Subsonic Filter
Phase-Switch
Bass Boost
Operating Voltage
Fuse Rating
Dimensions (B x H x L)
All Specifications are subject to change
IMPORTANT NOTES PRIOR TO INSTALLATION
• ATTENTION: Before you start with the installation, disconnect the ground connection from the
vehicle's battery in order to prevent short circuits.
• This device is only suited for a 12 volt system in a vehicle with negative ground.
• The radiated heat while operation requires sufficient air circulation at the place of installation. The
device may not be installed in small closed location or spaces without air circulation (e.g. spare
wheel recess or below the vehicle carpeting). Ensure sufficient protection against vibrations, dust
and dirt.
• Ensure that the input and output cables are sufficiently separated from the power supply cables.
• Otherwise interferences may occur.
• Ensure the accessibility of the fuse and the operating elements after installation.
• The reliability and performance of the device depends on the quality of installation. Preferably
consult an expert to install the system, particularly if you want to install several loudspeakers.
8
TR202A
1 x 100 W
1 x 200 W
50 – 150 Hz @ 12 dB/Octave
20 Hz fixed
0° / 180°
0 – 18 dB @ 45 Hz
+12 V (9 – 15 V), negative ground
10 A
245 x 75 x 345 mm