Water Tank - Philips HD7693/90 Mode D'emploi

Put pre-ground coffee (filter-fine grind) in the
8
filter until the Aroma Control indicator is in
the OK position and close the filter holder
lid (Fig. 7).
Press the on/off button to switch on the
9
appliance.
• The red power-on light goes on.
When all the water has passed through
10
the filter, you can remove the jug from the
appliance.
Warning:
B
If you remove the jug for more than
30 seconds before all the water has passed
through the filter, the filter may overflow.
Press the on/off button to switch off the
11
appliance after use.
Note:
D
The appliance switches off automatically after
2 hours.
Remove the filter holder (Fig. 8).
12
Throw away the paper filter. (Fig. 9)
13
let the appliance cool down for at least
14
3 minutes before you start brewing coffee again.
6 Cleaning
Warning:
B
Never immerse the appliance in water.
Unplug the appliance.
1
Clean the outside of the appliance with a
2
moist cloth.
Remove the filter holder.
3
Clean the jug and the filter holder in hot
4
water with some washing-up liquid or in the
dishwasher.
After cleaning, rinse the jug with fresh hot
5
water.

6.1 Water tank

Remove the water tank from the appliance.
1
4222_200_0054_1_DFU-Redesign_A5_v2.indd 7
Remove the cover from the water
2
tank (Fig. 10).
Clean the water tank in hot water, if necessary
3
with some washing-up liquid.
Note:
D
If you use a washing-up brush, be careful not
to damage the valve in the bottom of the
water tank.
Warning:
B
Do not use an object with sharp edges to
clean the water inlet on the appliance.
Rinse the water tank with fresh water after
4
cleaning and put it back onto the appliance.
7 Descaling
Regular descaling prolongs the life of the appliance
and guarantees optimal brewing results for a long
time. the appliance measures the amount of scale
and notifies you when the appliance needs to be
descaled.
•
The yellow descaling light goes on when you
need to descale the appliance (Fig. 11).
To descale the appliance, perform the following steps:
Fill the water tank with white vinegar
1
(4% acetic acid). Do not put a filter and
ground coffee in the filter holder.
let the appliance complete two brewing cycles.
2
see chapter 'Using the appliance'. let the
appliance cool down for 3 minutes before you
start the second brewing cycle.
let the appliance complete two more
3
brewing cycles with fresh, cold water to
remove all vinegar residues.
• You can also use an appropriate liquid
descaler. In this case, follow the instructions
on the package of the descaler.
Warning:
B
Do not use a descaling powder.
Clean the separate parts (see chapter
4
'Cleaning').
7
8/16/13 8:22 AM