Safety Specifications; Installation Specifications; Environmental Specifications - TDK-Lambda CM4 Série Manuel D'utilisation

Table des Matières

Les langues disponibles

CM4 Series Instruction Manual

Avoid excessive shock or vibration.

If series and/or parallel combinations of outputs exceed safe voltage and/or energy levels, the final equipment manufacturer must

provide the appropriate protection for both users and service personnel.

Parameter

Details

Input to Output (2 MOPP)

Input to J2 standby control (2 MOPP)

Isolation Voltages

Input to Chassis (1 MOPP)

Global signals (J3) to Output/Chassis

Output to Output/Chassis

Earth Leakage Current

Normal Condition, 264Vac, 63Hz, 25°C

Touch Leakage Current

Normal Condition / Single Fault Condition

Parameter

Equipment class

Overvoltage category

Material Group

Pollution degree

Parameter

Air

Operational limits subject to appropriate de-ratings

Temperature

Humidity

Altitude

EN 60068-2-27: Half sine, 3 axes, 3 positive & 3 negative

Shock

810G: Method 516.6, Procedure IV, Transit drop

EN 60068-2-6: Sine,10 – 500 Hz, 3 axes, 1 oct/min., 10 cycles each axis

EN 60068-2-64: Random, 5 – 500 Hz, 3 axes, 30 min.

810G: Method 514.6, Procedure I (General Vibration)

Vibration

Category 4 (Trucks & Trailers, Composite wheeled vehicle), Figure 514.6C-3.

Category 7 (Aircraft, Jet cargo), Figure 514.6C-5 General exposure

Category 24, (All, Minimum integrity) Figure 514.6E-1

Thermal

MIL-STD-810G Method 503.5 Procedure I-C. Multi-cycle. 3 shocks.

shock

Notes

Some specifications may not be met below -20°C.

Note: All output voltages/variants may not be available as standard units, refer to datasheet for standard product range. These (and

other variants) may be available as non-standard or custom units, please contact our sales team for details.

Specifications