Operating Your Kettle - DeLonghi DSJ900 Série Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATING YOUR KETTLE

PREPARING YOUR KETTLE:
1.
Place the kettle on a flat, level surface away from any edge.
2.
Plug the unit into a 120V / 60Hz only outlet.
3.
The kettle must be properly positioned on the power base, or it will not operate.
4.
The lid must be properly closed during the boiling process. CAUTION: If the lid
is not completely closed, boiling hot water could splash out.
SUGGESTIONS:
1.
To improve the quality of your drink, always use fresh water.
2.
Empty the kettle after each use.
OPERATING YOUR KETTLE:
1.
Fill the kettle with water. The kettle must be filled between MAX and 200ml
(1 cup). Never overfill the kettle, this could cause hot boiling water to splash
out.
2.
Place the front of the water filter into the spout area, and then clip into place.
Never use the kettle without the filter. Figure 2.
3.
Make sure the lid is properly positioned on top of the kettle.
4.
Place the kettle on the power base. If the kettle is not positioned properly on
the power base, the kettle will not operate.
5.
Switch the kettle on by moving the toggle into the "ON" (down) position. The
toggle switch will illuminate indicating that the kettle's power is on.
6.
The kettle will now boil the water and switch off automatically when it's
complete. You will know when it's done boiling when the toggle switch is no
longer illuminated.
7.
Remove the kettle from the base for convenient and easy serving. CAUTION:
Do not place hot kettle on furniture or flammable materials. Make sure to place
the toggle switch in the up position to turn the kettle "OFF" before removing the
kettle from the base for serving.
8.
To boil water again, wait a few seconds. The kettle needs time to reset itself.
Push the toggle switch down into the "ON" position. The switch will illuminate
and the kettle is reset and ready to boil water again.
9.
NOTE: If you switch the kettle on with too little water, your kettle will automati-
cally shut off. Let the kettle cool down before refilling. When it has cooled
down, the kettle will reset itself.
-6-

Publicité

Table des Matières
loading

Table des Matières