Dentatus ARH2 Mode D'emploi page 8

DENTATUS ARTICULATORS ACCESSORIES,
see illustrations on cover, fig 1, 7, 8 (left)
Solid Detachable Incisal Table
The Solid Incisal Table (23) can be tilted
anterior-posteriorly. The Table is detachable
and can be interchanged with the fully ad-
justable Segmented Incisal Table shown in
figure 8.
Figure 7
20. Incisal Table Groove for Positioning of
Individual Anterior Guidance
21. Lock Screw for Incisal Table
22. Calibration for Incisal Table Setting
Interchangeable segmented
incisal table
The Segmented Incisal Table can be adjusted
and locked in the desired position. It requi-
res a Special Incisal Pin with a flat tip (III),
which allows immediate rise in any lateral
movement.
The Incisal Table can be tilted anterior-pos-
teriorly in the horizontal plane and locked in
the desired position by its Lock Screw (21).
Figure 8
I Special Set Screw
II Lock Nut for Set Screw
III Special Incisal Pin with broad tip
21. Lock Screw for Incisal Table
22. Calibration for Incisal Table Setting
Mounting plates
fig 9-10 (right)
The Mounting Plate ARH-Z is cast of zinc.
The ARH-ZC is entirely molded in fiber rein-
forced composite. Lighter in weight and easer
to clean, but with an equally high stability as
the zinc plates.
Figure 9
Zinc Mounting Plate
Figure 10
Composite Mounting Plate
6