Titan UR 1250 Notice D'emploi page 3

continue searching.
- When your appliance reacts you can also try out other
buttons without interrupting the search. If some buttons
do not work properly, simply continue searching by
pressing ON/OFF POWER
6. When your appliance reacts correctly, press
the appliance button, e.g.
saving of found code. The lamp (LED) goes out.
- The last code entered remains stored. The search
stops after approx. 30 seconds of inactivity.
Vivanco GmbH, D-22926 Ahrensburg, E-Mail: hotline@vivanco.de, Helpline: +49 (0) 4102 231135
Manual code search
1. Switch on the appliance to
be controlled. Program is run-
ning.
2.
To prepare code search,
press the OK button and the
appliance button, e.g. TV, sim-
ultaneously until the
(LED) lights constantly.
3. Then point the remote con-
trol at the appliance to be con-
trolled.
4. Briefly press the ON/OFF
POWER button once. The
lamp (LED) blinks.
5. Press the ON/OFF
POWER button about any 1
second so often until the appli-
ance, e.g. your TV reacts by
power off.
- You can invert search direc-
tion by pressing the OK button
and then POWER again.
- If your appliance
switched itself off, you must
switch it back on again, e.g.
on the appliance or with the
original remote control, to
again.
TV for end of searching and
lamp
has
5. Finally, test the control code setting by trying
to control, for example, your DVD appliance (UR 1300
only). If it does not work correctly, please try the code
search again. The code search then begins with the
found code in the sequence.
- Remember to switch your appliance, e.g. DVD, back
on again if you wish to continue searching.
Automatic code search
1. Switch on the appliance to
be controlled. Program is run-
ning.
2. To start the code search,
press the OK button and the
appliance button, e.g. TV,
simultaneously for more than
3 seconds until the lamp
(LED) goes off briefly.
3. Then point the remote
control at the appliance to be
controlled while the remote
control emits a different
ON/OFF signal every 1-2
seconds.
- You can reverse search dir-
ection at any time by pressing
OK button.
4. When your appliance re-
acts, press any button except
OK within 1-2 seconds, to
end the search and save
code..
– If you ended the search too
late, continue to search using
the Manual Code Search
(see above).
3