Berger & Schroter 31907 Mode D'emploi page 3

(GB) 6x5W LED-Rotating Spotlight, Art.-Nr. 31907
Caution!
To prevent damages read this manual carefully. These operating instructions
belong with this product. They contain important information for putting it
into service and operating it. This should be noted also when this product is
passed on to a third party. Therefore look after these operating instructions
for future reference.
Safety instructions
1. The spotlight is not allowed to use in public traffic.
2. Use the spotlight only in dry environments.
3. Do not modify the suction base. The suction base can only fit on flat and smooth
surfaces.
Use only the suction base for attaching the spot light. Make sure the base fits proper to
surface without air passing into the base. Otherwise the spotlight may fall down.
4. Do not direct the spotlight to the face of other persons and never look directly into the
spotlight - it can damage the eyes!
5. Keep out the spotlight of reach of children when using and storing - damage!
6. Never touch the front glass when using the spotlight - damage of burning!
The spotlight is also very hot during the cooling phase after using!
7. Let the spotlight cool down after using, before storing it. Never store e.g. into the car
directly after using!
8. Keep minimal distance to flammable objects like printed on the nameplate of the spot-
light. Never install and use the spotlight on or near flammable objects.
9. Handle with care. Avoid thrusts and vibrations - this can induce the early blackout of the
halogen lamp.
10. Handle the headlight gently, avoid strong shocks and vibrations.
Using instructions
1. Place the spotlight with the suction base on flat and smooth surface. The lever must be
turned to the left.
2. Turn the lever full to the right. The suction base sucks in.
3. Put the 12 V plug into cigarette lighter socket. If the cigarette lighter socket takes only
power, when the motor ignition is on, switch on the ignition (see your car manual).
4. Switch on the spotlight with the rocker switch on the cable remote.
5. Move the spotlight by pushing the arrow keys on the cable remote. Observe the safety
instructions.
6. Switch off the spotlight after using and unplug the plug from the cigarette lighter socket.
7. Let the spotlight cool down. After this detach the suction base by turning the lever to the
left.
3