Rexel ClassicCut CL200 Manuel D'utilisation page 5

Laser light
D. Before use, insert the batteries provided (2 x AAA -
1
1.5v) into the battery compartment located below the
carry handle.
Laser Light Alignment
2
B. The laser-cutting guide may become out of alignment
with the cutting edge. Follow these instructions for the
re-alignment process.
• Use the Allen key included with your guillotine.
Insert the key into hole A and into the Allen screw. By
turning the screw clockwise, the entire length of the
laser beam move to the right. By turning the screw
anti-clockwise, the entire length of the laser beam will
move to the left (see graphics).
• Using the Allen key, insert the key into hole B and into
the Allen screw. By turning the screw clockwise, the
bottom angle of the laser beam will move to the left. By
turning the screw anti-clockwise, the bottom angle of
the laser beam will move to the right (see graphics).
Cutting restrictions
• Remove staples, paper clips etc. before cutting.
• Do not cut metal film, film containing glass etc.
• Do not cut more sheets than cutting capacity allows.
• Do not carry guillotine by holding on to the cutting blade
handle.
• Always operate guillotine with both hands and on a stable
base or desk.
• Check the fittings of the blade and safety cutting rail from
time to time.
Guarantee
Operation of this machine is guaranteed for two years
from date of purchase, subject to normal use. Within the
guarantee period, Rexel will at its own discretion either
repair or replace the defective machine free of charge.
Defects due to misuse or use for inappropriate purposes are
not covered under the guarantee. Proof of date of purchase
Register this product online at www.rexeleurope.com
CL410
Operating the guillotine
CL420
Place the guillotine on a stable, flat surface such as a
1
table.
Unlock the safety cutting arm latch (5) and lift cutting
2
arm into cutting position.
C1/C2. CL200/CL410: With the left hand, place your
3
paper in the desired position. Use your left hand to press
down the paper clamp.
C3. CL420: Place the paper under the Heavy Duty
Paper clamp as well as the Safety Guard. Adjust the
paper according to the cutting desired. Hold the sheets
securely into place and press the paper Clamp handle
down to lock it. To unlock paper clamp, lift the handle
back up.
B. CL410/CL420: To switch on the Laser light, simply
4
press down the laser button located on the upper side of
the guillotine. The laser light will provide a straight line,
indicating the exact cutting position. After use, you can
switch off the laser light, however it will automatically
turn itself off after 4-10 minutes, by gradually fading. To
obtain a brighter line, switch off the laserlight and turn it
on again.
In addition to the laser light, use the grid and Paper
5
Guides to ensure precise cut.
When finished with the guillotine, always place the
6
cutting arm in the down position and secure the handle
safety latch.
Located on the top of the machine, the carry handle (8)
7
makes it easier for you to move your guillotine.
Service
Do not attempt to service or repair the safety guard, retaining
bracket/screw, blade arm, or any other part of the unit
yourself. If your guillotine is under warranty return it to the
point of purchase for replacement or repair. If your guillotine
is no longer under the point of purchase return period and
requires replacement or repair, please contact your supplier
for further assistance.
will be required. Repairs or alterations made by persons not
authorised by Rexel will invalidate the guarantee. It is our
aim to ensure that our products perform to the specifications
stated. This guarantee does not affect the legal rights
which consumers have under applicable national legislation
governing the sale of goods.
G
5