If The Machine Does Not Work - Westpoint WMC Série Manuel D'utilisation

Does not work
(indicator light off)
Does not work
(indicator light on )
Does not
Take in water
Takes in and
discharges water
Continuously
Does not
discharge water
and does not spin

IF THE MACHINE DOES NOT WORK

Before consulting the technical assistance service, check that the
following operations have been carried out. This may lead to a saving in
both time and money.
Check that:
1) The power supply is available at the mains.
2) The plug is inserted correctly in the socket.
3) The programmer knob
fitted) is pressed*.
4) The door is closed.
5) Consult technical assistance.
Check that:
1) The programmer knob (P) is on the selected program.
2) Refer to problem "Does not take in water".
Check that:
1) Water is present in the supply system.
2) The tap is turned on.
3) The water feed hose is not kinked.
4) With the power disconnected, clean the inlet filter located between the
tap and discharge hose**.
5) Consult technical assistance.
Check that:
1) The discharge hose is at the correct height (60-90cm) ***.
2) The discharge hose outlet is not submerged under water.
3) Consult technical assistance.
Check that:
1) The discharge hose is positioned correctly.
2) The discharge hose is not kinked.
3) The detergent hose is not excessive.
4) The soap powder container is not blocked.
5) The detergent is the correct type for the washing machine.
* * See "Use of the machine" (page See "Use of the machine" (page 6) 6) 6) 6)
* * See "Use of the machine" (page See "Use of the machine" (page
** See fig .7 (page 4) ** See fig .7 (page 4)
** See fig .7 ** See fig .7 (page 4) (page 4)
*** See fig.8 *** *** *** See fig.8 (page 4) See fig.8 See fig.8 (page 4) (page 4) (page 4)
(P)
is pulled out, or the start pushbutton (if
9