Capacitance Measurement; Resistance Measurement; Diodetest - LaserLiner ClampMeter XP Mode D'emploi

Capacitance measurement

7
1.
Capacitance measurement

Resistance measurement

8
1.
Ω
Diode test
9
1.
Diode test
If "O.L." appears on the display instead of a measured value, the diode has either been tested in the
reverse direction or is faulty. If 0.0 V is measured, the diode is faulty or a short-circuit has occurred.
Components (7: Resistors, 8: Capacitors, 9: Diodes) can only be measured
!
correctly in isolation. It may therefore be necessary to disconnect the components
from the rest of the circuit.
!
To avoid incorrect results the measuring points must be free of dirt, oil, solder lacquer or similar.
!
The components must be off-circuit.
2.
Black
Connect the measuring contacts
to the object to be tested
2.
Ω , diode check and
continuity check selection
2. 3.
Ω , diode check
and continuity
check selection
ClampMeter XP
3.
Red
In the case of poled capacitors,
3.
Connect the measuring contacts
Red Black
connect the positive pole
to the red test prod
Black
to the object to be tested
Red Black
Forward direction
Red
21
EN