Configuration Programming - Gewiss Chorus GW 10 861 Notice D'utilisation

A) Remove the detector front plaque and assemble the magnet as shown on the previous
pages
B) Insert the batteries into the plastic housing, being careful to respect the polarities
marked on the detector.
C) Activate detector code acquisition mode on the GW 20 470 / GW 20 481 burglar alarm
control units.
D) Position the plate near the sensitive area of the magnet (the red LED blinks once to
indicate transmission made) in order to store the detector code in the control unit.
E) Set the detector's parameters on the control unit (belonging to the day/night group,
entry/exit route, supervision, etc.).
F) Deactivate acquisition mode on the GW 20 470 / GW 20 481 control units.
G) Install the detector in the permitted positions (to this end it is useful to refer to the
previous drawings). Replace the plaque and check the operation of the device with test
transmissions.
WARNING: failure to take care in reclosing the container with the consequent Tamper
circuit fault (detector removal alarm contact and plaque removal alarm magnet) leads to the
generation of a tamper alarm at each transmission.
The tamper code is also appended to all other transmissions of the sensor: it is therefore
possible, for example, that the alarm trips during the day due not to the movement
registered by the sensor, ignored with the control unit switched off, but due to the tamper
signal appended to the intrusion transmission just made.
USER INSTRUCTIONS

Configuration programming

35
E
N
G
L
I
S
H