Lubricating The Guide Bar And Saw Chain - Shindaiwa PT262S Manuel D'utilisation

Before you start
Fuel supply

Lubricating the guide bar and saw chain

 Do not add so much fuel that it reaches the mouth of the fuel
tank (A). Keep the fuel within the prescribed level (up to the
shoulder level (B) of the fuel tank).
 Tighten the fuel tank cap securely after refuelling.
1. Wipe debris from around oil fill cap.
2. Remove oil fill cap and fill reservoir with a quality, low viscos-
ity guide bar and saw chain oil.
 The discharge volume of the automatic oiler is preset to de-
liver 3 to 4 ml/min. at normal operating RPM. During heavy
or dry cutting conditions the oil discharge volume may be
adjusted to assure adequate lubrication. Refill the oil reser-
voir with each tank of fuel.
IMPORTANT
 To prevent plastic deterioration, do not use synthetic or sili-
cone based oil.
12
NOTE