Cleaning And Storage; Troubleshooting - Eurotops 01505 Mode D'emploi

The device is equipped with overheating protection; it switches off if it overheats.
In this case, turn the dial (8) to the 0 position, pull out the mains plug and allow the
device to cool down. It will be ready for use again after approx. 10 – 15 minutes.
1. Place the device on a dry, level, fi rm and heat-resistant surface.
2. Insert the mains plug into a properly installed plug socket that is easily accessible.
3. Turn the dial to position
window (1).
4. To switch on the heating function, turn the dial to the position
increase the level of heating, turn the dial to the position
Turn back the dial to position
5. To switch on the swivel function, turn the dial to the
6. Set the temperature you want (0 – 85°C) with the temperature dial (9).
7. To switch off the device, turn the dial to the 0 position.
8. Remove the mains plug from the plug socket after use.

Cleaning and Storage

PLEASE NOTE!
■ Pull the mains plug out of the socket and allow the device to cool down completely
before doing any cleaning!
■ Do not use any caustic or abrasive cleaning agents for cleaning. These can damage
the surface.
• Dust down the device if necessary or wipe it down with a damp cloth if necessary.
Then wipe it dry with a dry cloth.
• When not in use, the device should be stored in a clean, dry place which is protected
from dust and is not accessible to children and animals.

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps that are listed, contact the cus-
tomer service department.
Do not attempt to repair a defective electrical device yourself!
Problem
The device does not
work.
01505_de-en-fr-nl_A5_V3.indb 15 01505_de-en-fr-nl_A5_V3.indb 15
15
. The "fi replace look" lighting (2) is switched on behind the
to switch off the heating levels.
Possible cause/solution
• Is the mains plug inserted in the socket correctly?
• Is the socket defective? Try another socket.
• Check the fuse of the mains connection.
• Has the dial (8) been turned at least to the
• The safety switch has been triggered. Check whether the
device is currently on a fl at surface.
for heating level 1. To
for heating level 2.
position.
position?
07.05.2018 11:32:08 07.05.2018 11:32:08
EN