Velleman SPBS5 Mode D'emploi page 5

1. buzzer
2. black (-) cable
3. red (+12VDC) cable to reversing light
4. sensors
5. Installation
Refer to the illustration for an overview of the different components.
Locate the control unit (1) in the boot, away from rain, heat and shocks. Use the
included double-sided tape. Make sure to lay the wiring in such way to avoid
damage or accidental disconnection.
We recommend gluing the buzzer (2) to the back of the back seat. Connect to
the control unit.
Mark the installation spots on the bumper (see fig. for the installation interval).
Drill holes using a powerful electric drill (not incl.) and the included hole saw.
Insert a sensor (3) into each hole and connect to the control unit.
SPBS5 5 VELLEMAN