Fitting The Carrying Strap - Blaser Optics Primus 8x30 Mode D'emploi

For cleaning heavy soiling caused by dust
and sand, the eyecups can be easily re-
moved .
1 . Screw in the eyecup fully in clockwise
direction and unscrew it via a slight
resistance .
2 . Then remove the eyecup towards the
top against a slight resistance . Just
rinse with running water, let it dry off,
and install it again .
Always keep your binoculars in a
well-ventilated, dry and cool place . Wipe
the wet binoculars before storing them in
the case . Protect your binoculars against
shocks and falls .
18

Fitting the carrying strap

The Blaser carrying strap included in the
scope of supply can be fitted both with
the eyepiece cap attached to one side
and to both sides .
1. Hold strap, pull at the housing front
[3], and fully remove interior holder [2]
from the housing (Fig . 1) .
2. First loosen the strap from the interior
holder [2], then from the hold-down
clamp [1] (Fig . 2) .
3. Lead the loose strap through the lug of
the eyepiece cap and that of the bin-
oculars . The eyepiece caps can be at-
tached to one side on the left or right,
or to both sides (Fig . 3) .
4. Then lead the strap through the hold-
down clamp [1] again and fix it to the
interior holder [2] (Fig . 4) .
5. Fully slip the housing [3] over the inte-
rior holder [2] again and repeat fixing
the carrying strap to the other side of
the binoculars (Fig . 5) .
1
1
1
1 3
2 3
19