Special Wash Cycles And Options - SCHOLTES LTE M812 L Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Special wash cycles
and Options
Notes:
Optimum performance levels when using the "Fast" and "Express
40'" cycles can be achieved by respecting the specified number
of place settings.
To reduce consumption, only run the dishwasher when
it is full.
Note for Test Laboratories: for information on comparative EN
testing conditions, please send an email to the following address:
ASSISTENZA_EN_LVS@indesitcompany.com
Wash options
If an option is not compatible with the selected wash cycle
(see table of wash cycles), the corresponding LED flashes
rapidly 3 times and beeps will sound.
Delayed start
The start of the wash cycle may be delayed for a
period of time between 1 and 12 hours.
1. Press the DELAYED START button: the corresponding
symbol appears on the display; each time you press the
button, the time (1h, 2h, etc. up to max. 12h) from the start
of the selected wash cycle will be increased.
2. Select the cycle and close the door: the timer will begin
counting down;
3. Once this time has elapsed, the indicator light switches
off and the wash cycle begins.
To adjust the delay time and select a smaller period of time,
press the DELAYED START button. To cancel it, press the
button repeatedly until the selected delayed start indicator
light switches off. The wash cycle will start automatically as
soon as the door is shut.
The Delayed Start function cannot be set once a wash cycle
has been started.
*
LIGHT TECH
Some dishwasher models are equipped with a green
indicator light in the gap between the door and kitchen top
providing information on the phase of the current wash cy-
cle. One of the following operating modes can be selected:
a) Disabled function
b) When the cycle starts the light goes on for few seconds,
stays off during the cycle and flashes at the end of the cycle
(default mode)
c) The light stays on during the cycle and flashes at the end
of the cycle. If the delayed start was set, the light goes on
either for the first few seconds or the entire duration of the
countdown, based on whether mode b) or c) was set.
The light goes off every time the door is opened.
To select the mode you prefer, switch on the machine, hold
down button P until one of the three letters appears on the
display, press button P until you reach the desired letter (or
mode), hold down button P to confirm the selection.
*
Only available in selected models.
EN
29

Publicité

Table des Matières
loading

Table des Matières