AutoAqua Smart Stir SS-100 Mode D'emploi page 3

Operation
1
Fill the vial with your water sample and add the reagent according
to the instructions of the test kit manufacturer.
2
Put the magnetic stirring bar in the vial.
3
Place the vial in the Smart Stir Base and press the power button.
4
Press the power button again to stop stirring. Or it will stop
automatically after 5 minutes.
5
Don't forget to remove the stirring bar with the iron wire before
emptying the vial.
Reagent
Water
1
Notice
1. Please charge Smart Stir before rst use.
2. Please ll the vial before starting stirring.
3. Please take out the stirring bar with the iron wire rst before
emptying the vial.
4. Smart Stir will stop operation automatically after ve minutes.
5. The power button will ash blue when the battery is running low.
6. Please do not charge Smart Stir with a fast charger or it may
be damaged.
Stirring Bar
2 3 4
&
2
English
5