Télécharger Imprimer la page

Imiola HAK-POL F/023 Manuel D'installation page 5

Masquer les pouces Voir aussi pour F/023:

Publicité

• Hak należy zamontować w fabryczne otwory zaklejone plastrem w kolorze podwozia.
Plastry należy zerwać.
• W technologiczne otwory należy włozyć specjalne wkładki z nakrętkami.
• Belkę haka A przykręcić do tylnego pasa i boków podłużnic śrubami M8x35 8.8 (pkt 7).
• Elementy haka F przykręcić do boków podłużnic śrubami M12x110 8.8 stosując tulejki E
(pkt 6) oraz skręcić śrubami M12x40 8.8 z belką haka A (pkt 2).
• Elementy haka C i D przykręcić do elementów F śrubami M12x35 8.8 (pkt 1) oraz
do podłużnic śrubami M10x35 8.8 (pkt 4).
• Dokręcić wszystkie śruby z momentem wg tabeli.
• Przykręcić kulę i blachę gniazda elektrycznego śrubami M12x70 8.8.
• Podłączyć instalację elektryczną.
• The towbar should be install in the technological points stucked with slice in colour
of the chassis. Is necessary to open this holes.
• Put special nuts "Caget nuts" in the technological holes.
• Screw the main bar A to the rear belt and sides of the metal clamps with
bolts M8x35 8.8 (points 7).
• Screw the elements F to the sides of the metal clamps with
bolts M12x110 8.8 using sleeves E (point 6) and screw to the main bar A with
bolts M12x40 8.8 (point 2).
• Screw the elements C and D to the elements F with bolts M12x35 8.8 (point 1) and
to the metal clamps with botls M10x35 8.8 (point 4).
• Tighten all the bolts according to the torque setting- see the table.
• Fix the ball and electric plate with bolts M12x70 8.8.
• Connect the electric wires.
• Monter le crochet dans les ouvertures d'usine, collées par le scotch en couleur de châssis.
Détacher les scotchs.
• Insérer les plaquettes spéciales avec les écrous dans les ouvertures.
• Serrer la traverse de crochet A à la partie arrière et aux ancs des longerons par les
boulons M8x35 8.8 (point 7).
• Serrer les éléments de crochet F aux ancs des longerons avec les
boulons M12x110 8.8 par les douilles E (point 6) et serrer avec les
boulons M12x45 8.8 à la traverse de crochet A (point 2).
• Visser l'élément C et D au crochet F par le boulon M12x35 8.8 (point 1)
et à la traverse de crochet par les boulons M10x35 8.8 (point 4).
• Serrer tous les boulons avec un couple de serrage selon tableau.
• Visser la boule et tôle de la prise électrique par les boulons M12x70 8.8.
• Raccorder le circuit électrique.

Publicité

loading

Produits Connexes pour Imiola HAK-POL F/023