Indel B TB15 Instructions D'utilisation page 16

ENGLISH
BATTERY PROTECTION LEVEL
It is possible to set three different battery protection threshold levels:
Battery protection
MIN.
MED.
MAX.
To enter the menu, switch the refrigerator on by pressing the ON/OFF button.
Press and hold the SET + ON/OFF buttons at the same time for several seconds to access the battery
protection level setting. The current setting will start to flash on the display.
Press the SET button a number of times to scroll through the three different settings:
1 Bar
2 Bars
3 Bars
Without having to press any other button to confirm, the display will automatically save the setting and
exit programming mode.
FAULTS
Any operation faults will be displayed after 90 seconds and will be presented on the display with the
following codes:
1
The thermostat has short-circuited or is not correctly connected to the control unit:
2
The compressor is blocked:
3
The ventilator is sending the control unit a value which exceeds 0.6A:
4
The cooling system holds too much gas and the compressor is not able to operate
at the minimum number of revolutions/rpm:
5
The ambient temperature is too high:
6
Insufficient voltage (Voltage below the cut-out value):
7 No communication between the display and control unit, a scrolling horizontal
line appears on the DISPLAY for a few seconds, the refrigerator turns itself off.
REPLENISHMENT
Avoid placing hot food in the refrigerator. Place the products so that they do not knock against each other
or break when the vehicle is in motion.
Ensure that the lid is always firmly on and reduce the time it is left open to the minimum possible.
14
Display
1 Bar
2 Bar
3 Bar
12V
9.6
10.1
11.1
TB15-18_new 2017_05-09-2017
TB 15-18
24V
21.3
22.3
24.3
R6
R3
R2
R4
R5
LO
-