Publicité
Les langues disponibles
Les langues disponibles
30~50cm
Air flow
•
Auto shut off
The water level shuts off the dehumidifier when
the tank is full, or when the tank is removed or
nor replaced in the proper position. When the
set humidity is reached, the unit will be shut off
automatically.
•
Continuous mode (Cont.)
This
function
dehumidification. The humidity level setting
③
and
④
cannot be used when continuous
operation is on.
•
Hygro Smart
©
At smart dehumidifying mode, the unit will
automatically control room humidity in a
comfortable range 45 % ~ 55 % according to
the room temperature. The humidity setting
function will be invalid.
Secondary fonctions
•
Timer
Press ⑤ to initiate the Auto start and Auto stop
feature, in conjuction with the "+"
"-"
④
key pads.
When the unit is on, first press the Timer button,
the Timer Off indicator light illuminates. It
indicates the Auto Stop program is initiated.
Press it again the Time On indecator light
illuminates.It indicates the Auto Start is
initiated.
When the unit is off, first press the Timer button,
the TIMER ON indicator light illuminates. It
indicates the Auto Start program is initiated.
Press it again the Time Off indecator light
illuminates.It indicates the Auto Stop is initiated.
Wet clothes
30~50cm
allows
a
maximum
mode (SMD)
③
Press or hold the UP or DOWN pad to change
the Auto time by 0.5 hour increments, up to
10 hours, then at 1 hour increments up to 24
hours. The control will count down the time
remaining until start.
The selected time will register in 5 seconds
and the system will automatically revert back
to display the previous humidity setting.
When the Auto start & Auto stop times are set,
within the same program sequence, TIMER ON
OFF indicator lights illuminate identifying both
ON and OFF times are now programmed.
Turning the unit ON or OFF at any time or
adjusting the timer setting to 0.0 will cancel
the Auto Start/Stop function.
When LED display window displays the code
of P2, the Auto Start/Stop function will also be
cancelled.
•
Turbo
Control the fan speed. Press to select either
High or Normal fan speed. Set the fan control
to High for maximum moisture removal. When
the humidity has been reduced and quiet
operation is preferred, set the fan control to
Normal.
•
Auto-restart
If the unit breaks off unexpectedly due to
the power cut, it will restart with the previous
function setting automatically when the
power resumes.
Wait 3 minutes before resuming operation.
After the unit has stopped, it cannot be
restarted for 3 minutes. This is to protect the
unit. Operation will automatically restart after
3 minutes.
•
Drainage continu (Ø 13.5mm)
Plug a water hose to the drain hose outlet of
and the
the device and the other to a floor drain or a
suitable drainage facility like a sink or a flush.
Cut off the plastic cover located at drain
hose outlet by a scissor. The drainage facility
should be lower than the drain outlet of the
unit. Make sure the connection of the water
hose and the drain hose outlet is tight and do
not let the water leak.
11
Publicité
